Floor Safety Standard Duty Slip Grip GRP Anti Slip Flat Sheet
As well as being unbeatable in price, the SlipGrip Standard Flat Sheets also maintain the excellent quality of the SlipGrip range. Best used to make slippery walkways and ramps safe, our Standard Flat Sheets are a general-purpose, tough GRP suitable for both industrial and commercial use.
Quick and easy installation – minimal downtime and can be walked on immediately.
Durable and tough chemical-resistant surfaces, make them suitable for both commercial and industrial use.
Easy to clean and replace if needed.
Suitable for a variety of substrates – wood, concrete, stone, and metal.
Ideal for ramps, walkways, fire escapes, landings, mezzanine floors, and areas of medium foot traffic.
Lengths: 800mm, 1200mm, or 2400mm
Black, Yellow, and Stone
How to Install:
You can install our SlipGrip Standard Flat Sheets easily and quickly with our SlipGrip GRP Flooring Sheet Fixing Kits. 1 fixing kit covers 1 full 2400mm x 1200mm sheet.
Ensure that the area is clean, dry and free from loose and friable material. Any “dished” or damaged surface areas should be patch repaired to provide a reasonably flat and consistent surface.
Dry fit all SlipGrip panels to ensure they fit freely and that they sit flat down on the surface. If required, SlipGrip can be trimmed on-site to suit, ideally using a skill saw with a 4mm diamond blade or an angle grinder with a 1mm blade.
Please ensure that goggles and gloves are worn at all times when any form of cutting is involved.
Fixing Kit Application:
Apply an approx. 6mm bead (this may need to be increased depending on the substrate conditions) of the high strength gap filling adhesive around the periphery of the underside of the SlipGrip panels approx. 25mm in from the edges. Then, starting from the bottom left corner come up at an angle (approx. 200mm across) and then down at an angle, to create a ‘peak and a trough’, repeat this until you reach the end. Immediately press the panel firmly to the substrate to ensure adequate transfer of adhesive (depending on the size of the bead, this will elevate the sheet by approximately 1-1.5mm). A firm bond will be achieved in about one hour under normal circumstances and conditions. Secure with mechanical fixings, as below.
Drill holes 50mm in from all edges at no more than 300mm apart from the centres. Depending on the width of the panels it may be necessary to provide fixing points at 600mm centres down the middle of the panels. As substrates vary considerably, additional fixings may be required to fix the panels down. If fixing down two pieces of the flat sheet that are constrained by sides (i.e. a ramp with the wall on either side) a 5mm expansion gap should be considered between the two or more sheets. This gap can be filled with a standard high-modulus mastic.